{1} {4}
{3}
水曜日, 9月 20, 2023 |
表面形状測定機は、製品の最表層の地形特性を測定するための計測機器です。これは、材料の主形状と、その表面のサブミクロン(μm)単位のテクスチャー変化を考慮した多点測定形式であり、一般に寸法的な割れや表面粗さとして特徴付けられる。
月曜日, 8月 21, 2023 |
形状測定は、被測定物の全体的な形状(平面度、真直度、平行度、真円度、円筒度)を測定するために行われるものである。これは、部品が最終製品の用途に適合することを保証するために重要であり、ひいては製品の性能を保証し、顧客満足を維持するための鍵となる。
月曜日, 6月 12, 2023 |
Metrology 4.0 ソフトウェアの「2D X Auto」機能 ローラーの始点と終点のエッジを正確に自動検出することで、ローラーベアリングの測定を簡素化し、粗さ、肉厚、寸法、うねりなどの分析を提供します。トラバース長を設定する必要がなくなりました!
月曜日, 5月 22, 2023 |
Contours refer to the nominal form of a surface, excluding irregularities that could be categorized as roughness or waviness. Characterizing the contours of a surface profile is complex as it can be inherently difficult to separate waviness from general form.
金曜日, 5月 19, 2023 |
多くの場合において、表面粗さは機能と密接に関連しています。例えば、2つの表面が互いに密接に移動接触している場合、その表面粗さはシール性や摩耗性に影響します。このことから、「平滑であればあるほど良い」と思われるかもしれませんが、他の要因が絡んでいることもあり、必ずしもそうとは限りません。潤滑が必要な場合、油を保持するために粗い谷が必要であることが分かっています。
月曜日, 11月 7, 2022 |
テイラーホブソン フォームタリサーフPGIノNOVUS 表面形状測定機のゲージアライメントと直径の測定方法。
木曜日, 10月 22, 2020 |
In this article you will learn the measurement of vibration on a finished bearing assembly, how some of the individual components could be tested by measuring on a roundness instrument and analysing using velocity analysis.